日本久久精品一区二区_扒开老师的粉嫩泬10p_成人免费无码大片a毛片视频_欧美写真视频在线观看_日本无遮羞调教打屁股_三级日本中文少妇_亚洲人妻无码电影播放_国产精品免费露脸视频_黄色在线免观看国产_五月婷婷六月丁香

    1. According to the selection of daily production mix lying machine. Because each batch mixer processing time of about 10 minutes, with the time of the feed materials, the processing time of each batch may be 15 minutes total, the four one hour continuous batch processing. If you choose the amount of 100 kg per batch processing mixer, processed 400 kg per hour. Users can choose according to their needs horizontal mixer.
    2. According horizontal spiral belt mixing [1] machine works, with a capacity for mixing double helix in the opposite direction to push the material should be basically the same. As the pitch should be less than the outer spiral band spiral bands, push the material to achieve a consistent ability to pitch in the outer spiral bands should be less than the spiral bands, and the width should be greater than the outer spiral bands, otherwise it would focus on the material in one direction. Therefore, the choice of horizontal mixer pay attention to this point.
    3. According to the design principle, the gap in the spiral ribbon mixer between the band and the case may be 4 mm to 10 mm, the material can be mixed with friction drive all participated. However, due to the friction coefficient of the particle size and material crushing is not the same, and therefore will participate in a variety of materials component mixing time is not the same, resulting in product uniformity. Currently, some manufacturers have been aware of it and the product has been improved. A machining precision is noted, that the bottom is reduced to about 3 mm gap; the other is formed between the shaft and the housing in the form of adjustable position, the gap between the housing and the spiral band can be always adjusted according to the amount of wear . When selecting the mixer, the two forms of the product should be the best choice.
    4. Select horizontal ribbon mixer should be noted that the material way. Timely communication with suppliers should choose their own form of valve technology, and do not choose the material in the form of side population. The reason: When the mixer, mixing is completed in a specified time, the shortest time to put a clear ensure uniformity of materials; such as spiral with a side opening gradually put the net, one wasted time, less than expected productivity, and second, The material has reached the optimum uniformity, but will make the material segregation excessive agitation, undermining the uniformity, thus losing the choice of horizontal mixer significance.
    5. Note that the use of horizontal mixer feeding order. Generally the first to vote aniseed, jade rice, soybean powder, and then cast the group of materials, such as premix. Note that some do not premix feed screw hoist applications disposable tipping bucket feeding or artificial feeding, to avoid loss of premix isolated the active ingredient.
    6. Use horizontal mixer, batch feeding should start after the mixer. At the end of the discharge mixing and do not stop, then the net material mixed batch. If the full load and then start, it will cause too much power from the motor and burned.
    Choose a suitable horizontal mixer and used properly, will significantly improve the quality of the mix, and will soon be a benign effect reflected in the production process. If we can better understand the self-made blends technology, but also to greatly reduce the cost of materials, thereby increasing profits.